Anyone have any ideas? - broken ironing board
I ironed a pair of pants in my apartment ... lol. broke my board, and he did it before I could get a new one. Anyway, I missed it, and click on the carpet with the iron and burned the carpet. no idea how to handle this situation?
Tuesday, January 5, 2010
Broken Ironing Board Anyone Have Any Ideas?
4 comments:
What you need:
Carpet glue
Glue Gun
Carpet Tractor (drums)
Replace carpet patch
Brush or a vacuum
Scissors
Book
Pencil
Carpet knife or a knife
Light sandpaper or steel wool
Step 1
Rubbing the burned area with sandpaper or steel wool, fused to easily remove the fibers.
Step 2
Brush or vacuum cleaner to remove the burn area no ashes or charred loose fibers. If the burn marks are gone, you can stop here. If you still see that burn, you must remove and replace the carpet (steps 3 to 8).
Step 3
Carefully cut, see the damaged area with a carpet knife or a knife (a burn), the extension of his court at least 2 inches (5 cm) above the edges of the at. Make sure only the support of the carpet - not cut down.
Step 4
Place the cut piece of paper. Draw with a pencil and cut out the pattern.
Step 5
Place your model on a remnant of carpet. Or you can use a carpet inconspicuous region like the back of a cupboard. Cut and remove the patch of carpet replaced.
Step 6:
With a hot glue gun, cover the back of the carpet glue the carpet replacement and control measures are taken. Edge edges with glue to prevent the patch that removed during routine cleaning or use.
Step 7
Mixture and seal the joints by rolling on the carpet was patched with a tractor (see B).
Step 8
Allow carpet to dry thoroughly before resumption of foot traffic.
------------------------------
Tips:
You can glue for carpet and rug tractor found in most hardware stores or home.
If the burn is not all the way to the back of the carpet or you are reluctant to cut and paste, you can cut the fibers of the fire hole and glue in alternative fibers. Clip of the new fibers, a new patch of carpet and glue in place with tweezers. This only works for small burned areas.
It is best to hire a professional to a piece of cutting where it (cabinet, etc.) If you try to fall in a hole not shown. You will never be as big as them, I've tried, I know first hand.
Dorton daughter is right, without changing the carpet in the room.
You can use the table instead of on the ground.
Dorton daughter is right, without changing the carpet in the room.
You can use the table instead of on the ground.
Post a Comment